Table of Contents
Advertisement
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
•
Do not operate the welder if the output cable electrode, MIG gun, wire or
wire feed system is wet. All the components and the welder must be
completely dry before attempting to use the welder.
•
Keep the welder in the OFF position when it is not in use.
•
Do not wear watches, rings, bracelets, or loose clothing when using the
welder.
•
Maintain a correct position while using the welder. Mount the welder on a
secure bench or cart to prevent if from tipping over or falling.
•
Connect the ground lead as close to the area being welded to ensure proper
ground connection.
•
Wear a full covered helmet, proper gloves, and protective clothing such as
coat and insulated footwear to prevent the skin from being exposed to hot
metals while welding.
•
Do not overload the welder to prevent it from being heated. Allow proper
cooling time between duty cycles.
Use safety goggles and ear protection:
•
Wear safety glasses with side shields when operating the
tool and verify that others in the work area are also wearing
safety glasses. Safety glasses must conform to American
National Standards Institute (ANSI Z87.1) requirements and
must provide protection from flying particles from the front
and the sides.
Always wear ear protection to help prevent hearing damage
and loss. Failure to comply may result in moderate injury.
Note: Recycle the unwanted materials rather than disposing of it as waste. Sort the tools, hoses, and
packaging in specific categories and take to the local recycling center or dispose of it in an
environmentally safe way.
FLUX-CORE WIRE FEED WELDER KIT 058-8194-4
8
MC-OM-01
Hide quick links:
Advertisement
Table of Contents
