Scanning And Sending To Smb/Ftp Server; Changing The Scan Feature Settings; Duplex - Samsung SCX-6x45 Series User Manual

1 Turn your networked computer on and open the web browser.
2 Enter your machine's IP address as the URL in a browser.
3 Click Go to access the SyncThru Web Service.
4 Click Machine Settings > SMB Setup > Server List. The Server
List is then displayed on the right side of the screen.
5 Click Add.
6 Select the index number from 1 to 20.
7 Enter a name in Alias for the Setup for the corresponding Server
List entry. This name will be displayed on your machine.
8 Select IP Address or Host Name.
9 Enter the server address in dotted decimal notation or a host name.
10 Enter the server port number, from 1 to 65535.
The default port number is 139.
11 Enter the share name of the server.
12 Put a check mark next to in Anonymous if you want to allow the
SMB server to be accessed by unauthorized persons.
By default, this is unchecked.
13 Enter the login name and password.
14 Enter the domain name of the SMB server.
15 Enter the location for storing the scanned image. This is the location
you entered in step 7.
16 Click Apply.

Scanning and sending to SMB/FTP server

1 Press Scan from the Main screen.
Note
If the authentication message shows, enter User Name
and Password. This message shows only when the network
administrator has set the authentication in SyncThru Web
Service. (Page 10.6)
2 Press Scan to Server.
3 Place the originals face up in the DADF. Or you can place a single
original document face down on the scanner glass.
4 Adjust the document settings in the Image tab.
5 Select Duplex and Resolution in the Basic tab.
Downloaded From ManualsPrinter.com Manuals
6 Press Scan to Server to show the SMB server list you entered in
the SyncThru Web Service.
7 Select the destination SMB server.
Note
You can select up to five destinations using both of SMB or
FTP servers.
8 Press Start on the control panel.
The machine begins scanning and then sends the scanned image to
the specified server.

Changing the scan feature settings

This part explains how to adjust the document settings for each scan job,
such as resolution, duplex, original size, type, color mode, darkness, and
more. The options you change will be maintained for a certain time, but
after that period, the options will be reset to default values.

Duplex

This feature especially applies when the original documents to be
scanned are two-sided. You can select whether the machine scans only
one side of the paper or both sides of the paper.
Press Scan > Scan to Email (Or Scan to Server) > the Basic tab >
Duplex. Use left/right arrows to toggle the values.
• 1 Sided: For originals that are printed on one side only.
• 2 Sided: For originals that are printed on both sides.
• 2 Sided, Rotate Side 2: For originals that are printed on both
sides. But the back is rotated 180 degrees.
Note
To use 2 Sided and 2 Sided, Rotate Side 2, you have to load
the originals on the DADF. Because, if the machine can not
detect the original on DADF, automatically changes the option to
1 Sided.
7.6
<Scanning>