Loading Paper; In The Tray 1 - Samsung SCX-6x45 Series User Manual

Media type
Transparencies • To avoid damaging the machine, use only
transparencies designed for use in laser printers.
• Transparencies used in the machine must be
able to withstand 180 °C, the machine's fusing
temperature.
• Place them on a flat surface after removing them
from the machine.
• Do not leave them in the paper tray for long
periods of time. Dust and dirt may accumulate
on them, resulting in spotty printing.
• To avoid smudging caused by fingerprints,
handle them carefully.
• To avoid fading, do not expose printed
transparencies to prolonged sunlight.
• Ensure that transparencies are not wrinkled,
curled, or have any torn edges.
Labels • To avoid damaging the machine, use only labels
designed for use in laser printers.
• When selecting labels, consider the following
factors:
- Adhesives: The adhesive material should be
- Arrangement: Only use labels with no
- Curl: Prior to printing, labels must lie flat with
- Condition: Do not use labels with wrinkles,
• Make sure that there is no exposed adhesive
material between labels. Exposed areas can
cause labels to peel off during printing, which
can cause paper jams. Exposed adhesive can
also cause damage to machine components.
• Do not run a sheet of labels through the machine
more than once. The adhesive backing is
designed for only a single pass through the
machine.
• Do not use labels that are separating from the
backing sheet or are wrinkled, bubbled, or
otherwise damaged.
Card stock or • Do not print on media smaller than 98 mm wide
custom-sized
or 148 mm long.
materials
• In the software application, set margins at least
6.4 mm away from the edges of the material.
Downloaded From ManualsPrinter.com Manuals
Guidelines
stable at 180 °C, the machine's fusing
temperature.
exposed backing between them. Labels can
peel off sheets that have spaces between the
labels, causing serious jams.
no more than 13 mm of curl in any direction.
bubbles, or other indications of separation.
Media type
Preprinted • Letterhead must be printed with heat-resistant
paper
ink that will not melt, vaporize, or release
hazardous emissions when subjected to the
machine's fusing temperature of 180 °C for
0.1 second.
• Letterhead ink must be non-flammable and
should not adversely affect printer rollers.
• Forms and letterhead should be sealed in a
moisture-proof wrapping to prevent changes
during storage.
• Before you load preprinted paper, such as forms
and letterhead, verify that the ink on the paper is
dry. During the fusing process, wet ink can come
off preprinted paper, reducing print quality.

Loading paper

In the tray 1

Load the print media you use for the majority of your print jobs in the
tray 1. The tray 1 can hold a maximum of 520 sheets of 75 g/m
plain paper.
You can purchase an optional tray and attach it below the standard tray
to load an additional 520 sheets of paper. (Page 12.1)
Loading paper in the tray 1 or optional tray
1 To load paper, pull and open the paper Tray and place paper with
the side you want to print facing up.
2 After loading paper, set the paper type and size for the tray 1. See
page 4.8 for copying and faxing or Software section for PC-
printing.
4.5
<Loading originals and print media>
Guidelines
2
(20 lb)