Section 3: Total Blender Overview; Section 4: Installation; Section 5: Care And Cleaning - Blendtec total blender Owner's Manual And User's Manual

SECTION 3 - BLENDER OVERVIEW
3.1 BLENDER MOTOR
• Touch Pad: Consists of nine buttons that contain pre-programmed settings for
selective blender control, a pulse button, and two speed control buttons.
• Blender Drive Socket: This is where the pitcher couples with the motor to turn the
blade assembly.
• LCD Information Center: Indicates status of unit as well as overload or over-tem-
perature conditions. It also displays the number of times a blend cycle button has
been pressed.
• Power Unit: This unit is located with the blender motor and contains the machinery
that runs the blender.
3.2 BLENDER PITCHER ASSEMBLY
The blender pitcher assembly consists of the blender pitcher, blade assembly, and lid.
• Pitcher: Made from a tough durable material to provide maximum efficiency and
clear visibility of blender performance.
• Lid: Flexible rubber lid seals liquids within the pitcher during blending.
• Blade Assembly: Stainless steel designed to provide fast, consistent blending.
• Power Switch: Located on the back lower-right corner of the motor base cover.
• Power Cord: Located at the back of the motor base cover.
• Motor Base Cover: Houses the power unit in a durable, easy-to-clean
polycarbonate.
NOTE: Filling the blender pitcher beyond the marked capacity is not recommended.
1. Place blender on a flat, clean, and dry surface.
2. Make sure a plug outlet is available within two feet of the blender motor.
3. Ensure the unit is turned off before plugging it into a separate 120-volt recep-
tacle.
4. Ensure that blender vents are unobstructed to allow proper cooling during use.
We recommend that surge protection be placed between the receptacle and the
blender motor.
SECTION 5 - CARE AND CLEANING
5.1 AFTER USE CLEANING
1. Add 1 cup of hot water and a drop of liquid dishwashing soap to the blender
pitcher.
(Refer to Figures 1 and 2)
SECTION 4 - INSTALLATION
7
www.blendtec.com