Belling IH613 User Manual And Installation Manual page 22

Fitting into work top
Cut a hole in the work surface to the
required size.
A clearance of at least 50mm should be
maintained between the cutout and any
rear or side wall.
The work top must be of heat-resistant
material or covered with heat-resistant
material.
Protecting the cut-out;
The types of chipboard used for work
surfaces swell relatively quickly in contact
with humidity.
Apply a suitable sealant to the cut edge to
protect it from moisture ingress.
This hob can be installed conventionally
(glass above the work top) or recessed
into the work top for a flush fit.
Self adhesive seal
Apply the self adhesive seal to the un-
derside edges of the hob glass. For best
results, the seal should be adhered along
each side in turn, as close to the edge as
possible, and trimmed at each corner, tak-
ing care to ensure a neat join.
Conventional Installation
Place the hob in the aperture, checking
the hob glass is covering the work top
along all four sides.
Set the front edge of the appliance paral-
lel with the front of the work top.
Locate and attach the securing clamps as
required, Tighten the screws so that the
hob is pulled down firmly against the work
top, thus ensuring a good seal.
DO NOT USE POWER TOOLS TO
TIGHTEN BRACKET OR
TERMINAL BLOCK SCREWS
- OVER - TIGHTENING COULD
RESULT IN DAMAGE TO THE
HOB
INSTALLATION
Recessed Method
Recess the work top to the appropriate
depth (Approx 5mm) and shape to fit the
hob (add 1mm to overall glass size).Insert
the hob into the recess, ensuring that the
foam seal is sitting correctly. Locate and
attach the securing clamps as required,
Tighten the screws so that the hob is
pulled down firmly against the work top,
thus ensuring a good seal. You may want
to fill any gap between the hob top glass
and the work top surface with silicone
sealant.
DO NOT fit silicone sealant under the
glass hob instead of the self adhesive
seal.
CONVENTIONAL INSTALLATION
1
Worktop Hob
1
SELF ADHESIVE SEAL
RECESSED METHOD
2 1
Worktop
Hob
1
SELF ADHESIVE SEAL
2
SILICONE SEALANT