Advertisement
Monitor SPECIFICATION:
Vertical refresh rate :
Horizontal Scan rate:
Horizontal scan rate is adjusted by H.Freq (Hold) as mentioned above.
Maximum Resolution:
Monitor Adjusted for:
Tube:
There is no vertical hold adjustment on this monitor.
If the monitor rolls vertically on some resolutions, you have to adjust the video
card's refresh rate to be adjusted near 80 Hz (not 85 Hz). In this case you need
to make sure that you have a Video card with a -1662 or -1097 specification (not
7285; 7285 spec may roll on some Sony 1962/1662 monitors)
This monitor requires a special video card to run all the modes properly on a PC.
For more information, please refer to www.mirage-mmc.com
This monitor does not function with a laptop/notebook running at 31.5 Khz( VGA
standard).
SONY Tube mask lines:
This monitor has 2 very fainted horizontal lines across the screen. This is how
SONY Trinitron Monitors are made to connect the tube masks together and this
is not a monitor defect. For further Information, please contact www.sony.com.
Monitor Labels and handling:
ü Please take extra caution when lifting this monitor. Normally we recommend 2
people to carry a 19" or higher size monitor as the monitor may weigh over 70
lbs.
ü In some cases, the serial # and front Logo of this monitor may have been
removed/replaced by the Manufacturer (HP, SUN Micro Systems, ...) so that
the original warranty is not provided from the manufacturer.
ü The 90 day limited warranty is provided by Multimedia Computers.
ü This monitor is carefully tested and refurbished to have the original display
specification. We apologize for any imperfections on the casing (bezel) as
these may not be new monitors.
Replacement video cards for this monitor can be obtained from: mirage-mmc.com
60-85 Hz
60- 80 KHz (Kilo Hetrz). Default set to 72Khz
1600x1200
1024x768
Sony Trinitron
Advertisement
