K-array KX12 User Manual page 11

KX12
4. Insert two joint blocks and secure each of them with the two 5x30 piston pins provided with the
system. The orientation of the joint blocks and the holes used will affect the angle between the fly
bar and the KX12, as shown below. We recommend setting an angle of 0° between the fly bar and
the first KX12 unit.
If you want to angle the speaker by 0°, +5°, +10° or +15°, position the joint block so that the
letter "A" is at the bottom. Plug a piston pin in the hole labeled "A", adjust the angle of the
speaker and plug the second piston pin in the hole corresponding to the desired angle.
If you would like to angle the speaker by -5°, -2.5°, +2.5° or +7.5°, position the joint block so
that the letter "B" is at the bottom. Plug a piston pin in the hole labeled "B", adjust the angle
of the speaker and plug the second piston pin in the hole corresponding to the desired angle.
The pictures below show how to regulate the angles
Ver. 1.4
11