Step 3: Provide Gas & Electrical Supply - Monogram ZGG24L Installation Instructions Manual

24' outdoor cooking center
Table of Contents

Advertisement

NOTE: Skip this step if you wish to connect to
Step 3
natural gas supply. Order ZX24NGB kit. Refer to
Provide
Natural Gas Conversion Instructions, page 10.
Gas &
Electrical
Supply
6
WARNING
PRODUCT STORAGE
When storing LP models indoors, discon-
nect the LP tank. Store the tank outdoors
in a well ventilated area.
Do not store spare LP tanks in or near the
Outdoor Cooking Center enclosure.
RANGEMENT DU
ATTENTION
PRODUIT
Lors du rangement des modèles à gas à
l'intérieur, il faut débrancher la bouteille
de gaz. Il faut remiser la bouteille de gaz à
l'extérieur, dans un endroit bien ventilé.
Il ne faut par remiser les bouteilles de gaz à
proximité de l'enceinte du centre de
cuisson en plein air.
• Connect the regulator to the quick
disconnect hose assembly.
• Check to be sure the main valve on the LP
tank is completely closed.
To connect the tank:
• Insert the coupler sleeve over the tank inlet,
turn clockwise to tighten.
To disconnect the tank:
• Turn off the main tank valve.
• Grasp the coupler sleeve and turn counter-
clockwise. Remove the inlet from the
opening.
ELECTRICAL SUPPLY
The rotisserie requires 120V, 60Hz., and
connected to an individual properly
grounded branch circuit protected by a 15
amp circuit breaker or time delay fuse.
The power cord on the rotisserie is equipped
with a three-prong (grounding plug which
mates with a standard three-prong grounding
wall receptacle to minimize the possibility of
shock hazard from this appliance.
If the electrical service provided does not
meet the above specifications, it is recom-
mended that a licensed electrician install an
approved outlet.
Installation
24" Outdoor Cooking Center
LP Hose
Pre-Attached
Inlet
L.P. Regulator
LP operating pressure is 10" W.C.
IMPORTANT: The LP tank must be a Type 1
Acme. Do not attempt to change or alter these
supplied parts Do not attempt to use the
regulator/hose assembly with a standard 510
POL tank/valve assembly.
DO NOT UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD.
• For built-in grill installations, locate the
electrical outlet on the right hand side.
Coupler Sleeve
Main Valve
L.P. Tank

Advertisement

Table of Contents
loading

Table of Contents