Table of Contents
Advertisement
Adjustments should not be required, unless
Step 6
vibration during transit or variations in local
Adjusting
gas supply make minor adjustments necessary.
the Burners
Adjustments must be made by a qualified
technician at the time of installation. Extreme
care should be used if adjustments are made
after installation.
• Turn gas supply on.
• Push and turn the burner control knobs to
• Flames should be blue and stable with no
TO ADJUST:
• The valve panel cover must be removed to
Low setting Adjustment:
Minor adjustments may be required due to
fluctuations in local gas pressure. Adjustments
to increase or decrease gas flow may be
necessary.
• Turn burner knob to "LITE" position.
• Turn the control knob to the lowest setting,
• Remove the knob by pulling straight out.
• Insert a thin-blade flat screwdriver into the
• Grip the shaft with pliers and turn counter-
8
the "LITE" position. Up to 20 seconds may be
required to to purge air from the lines.
yellow tips, excessive noise or lifting from the
burner. If any of these conditions exist turn
control to off and check air shutter and
burner ports for debris or spider webs.
1-1/2"
access the the air shutter. Follow the
instructions in Step 4, Test for Leaks.
all the way counter-clockwise.
valve shaft and hold. (3/32" blade width
recommended.)
clockwise to lower the flame, or clockwise to
increase the flame.
WARNING
Always check the low
flame size for stability. A burner flame
which is too small may go out or be extin-
guished easily. This can cause unburned
gas to escape and cause a hazardous
condition.
Installation
Air Shutter
• Locate and loosen the lock screw on the
face of the air shutter with a screwdriver.
• Turn burner to the "LITE" position.
• If the flame is yellow, indicating insufficient
air, open the air shutter to allow more air to
the burner.
• If the flame is noisy and tends to lift away
3/8"
from the burner, there is too much air. Turn
the air shutter to reduce the opening.
• Once adjusted, turn the burner off and
reverse steps to re-install the valve panel
cover.
• When the desired setting
is made, replace the
knob and turn burner
off.
vérifier la stabilité de la flamme au ralenti.
Une flamme trop petite peut s'éteindre
facilement. Ceci cause l'émission de gaz
non brûlé, ce qui est dangereux.
24" Outdoor Cooking Center
Grill Box
Lock Screw
Valve Stem
ATTENTION
Il faut toujours
Advertisement
Table of Contents
