Built-In Installations - Monogram ZGG24L Installation Instructions Manual

• This grill may be installed into a combustible
Built-In
Installations
• Combustible enclosures require the use of an
Clearances
• Allow 4" at the rear for lid clearance.
Built-In
Installations
ZX24TKBSS Trim Kit
This kit is available for non-combustible
enclosures. The trim will conceal the gap at
the rear and both sides of the opening.
• Secure trim to the sides and back with screws
• Place the grill into the enclosure.
Opening for
Double Access
Doors
Installation in a non-combustible enclosure.
• In a non-combustible (masonry) enclosure,
or non-combustible enclosure.
insulated jacket.
provided.
4" Min. for Lid
Clearance
24-1/2"
19"
35-1/2
Max."
Gas Inlet
18-1/4"
24-1/8"
the grill drops into the opening. A ledge on
each side is required for support.
Installation
24" Outdoor Cooking Center
• Allow at least 6" clearance on each side to
any non-combustible material located above
the cooking surface for counterspace. The 6"
clearance allows for placing and handling
the rotisserie motor and skewer.
• Allow at least 12" clearance on each side and
rear to combustible vertical materials.
Acorn Nut
ZX24JBSS Insulated Jacket
The insulated jacket is required for combus-
tible enclosures.
• Install left and right side pieces with bolts
provided.
• Secure bolts inside the grill with acorn nuts.
• Install back panel to side panels. Place the
grill into the enclosure.
If Installing 12" Min. to
an Electrical
Combustibles
Outlet for
4" Min. for Lid
the Rotisserie
Motor, Mount
on Right Side
19-1/2"
(6.5 AMP Min.)
35-1/2
Max."
8"
Opening for
Double Access
Doors
Installation in a combustible enclosure,
ZX24JBSS insulated jacket is required
• Combustible enclosures require ZX24JBSS
insulated jacket. The insulated jacket must
be supported by a ledge on each side.
• Construct the enclosure as shown. Install the
insulated jacket onto the grill. Place the
cooking center into the opening. No
installation hardware is required.
Back
Right Side
If Installing an
Electrical Outlet
for the Rotisserie
25-3/4"
Motor, Mount on
Right Side
(6.5 AMP Min.)
Gas Inlet
8"
18-1/4"
24-1/8"
5