Step 4: Test For Leaks; Step 5: Lighting The Grill - Monogram ZGG24L Installation Instructions Manual

Step 4
Test for
Leaks
• Do not use the grill until all connections
• Repeat leak test after each LP tank change.
• Check to be sure the main valve on the LP
• Make a soap solution of one part liquid
The valve panel must be removed to check the
valves and fittings.
• All control valves should be in the "OFF"
• Remove the knobs.
• Remove the 4 screws holding the valve panel
• Pull the panel outwards and unplug the wires
Step 5
Lighting
the Grill
• Open the lid.
• Turn all knobs to "OFF" position.
• Turn gas supply on at the LP tank or shut-off
NOTE: When lighting the burner for the first
time or after a LP tank change, allow up to 20
seconds to purge air from the lines.
• Push and turn control knob to "LITE"
WARNING
TEST FOR LEAKS
A complete gas tightness check must be
performed at the installation site.
V´ERIFICATION
ATTENTION
DES FUITES
Il faut vérifier que l'installation n'a aucune
fuite de gaz.
have been leak tested.
tank or the shut-off valve is in the "OFF"
position.
detergent and one part water.
position.
to the grill (2 behind burner knobs and two
below valve panel).
from the back of the rotary igniters.
WARNING
Do not attempt to
light the grill if the odor of gas is present.
ATTENTION
Il ne faut pas essayer
d'allumer le gril s'il y a une odeur de gaz.
CAUTION
Keep hands and face
as far away from the grill as possible when
lighting.
PRUDENCE
Pendant l'allumage,
il faut maintenir les mains et le visage aussi
loin que possible du gril.
valve.
position, immediately turn the rotary igniter
knob next to the burner knob.
Installation
24" Outdoor Cooking Center
4 Valve Panel
Attachment Screws
Igniter
Wires
TO TEST:
• Apply the soap solution around the
connections, valve and tubing.
• Turn the gas supply on.
• Check all connections from the supply line
or LP tank up to and including the manifold
pipe assembly.
• If a leak is detected, turn gas supply to off
and tighten fittings. Turn the gas on and
check again.
NOTE: The spark will produce a snapping
sound. This is normal.
• If the burner does not light within 4
seconds, turn knobs to "OFF" and wait 5
minutes for the gas to dissipate before trying
again.
• If the burner does not light after several
attempts, the burner can be lit with a match.
TO MATCH LIGHT:
• Strike a match and hold over the match light
hole at the top left side. See illustration.
• Push and turn the control knob to "LITE".
Match
Light
Hole
WAIT 5 MINUTES BEFORE RELIGHTING A
HOT GRILL.
7