Table of Contents
Advertisement
Parts supplied:
• Natural gas regulator
• Natural gas orifices
• Adapter 1/2" to 3/8" flare fitting
• Two, 1/2" NPT close nipple
The grill and its individual shut-off valve must
be disconnected from the gas supply during
any pressure testing of the system at test
pressures in excess of 1/2 PSIG.
The grill must be isolated from the gas supply
system by closing its individual shut-off valve
during any pressure testing of the system at
test pressures equal to or less than 1/2 PSIG.
Step 1
Check with local gas utility or with local codes
for instructions on installing gas supply lines.
Install
Be sure to check on type and size of run and
Fittings &
how deep to bury the line. If the gas line is too
small, the grill will not function properly.
Regulator
• Install a manual gas shut-off valve in an easily
• Use threading compound on non-flare
• Make connections as shown.
• Remove quick disconnect hose assembly from
• Leave flare fitting in the manifold pipe (1/2"
• Attach installer supplied gas line to end of
• Install regulator to gas line.
• Install 1/2" NPT close nipple to supplier
• Check to be sure the regulator arrow points
10
accessible location.
fittings only. Do not use threading compound
on the male end of the 1/2 NPT to 3/8 flare
adapter.
manifold pipe.
to 3/8" flare).
flare fitting on the manifold.
installed shut-off valve.
in the direction of gas flow, towards the grill
and away from the gas supply.
ZX24NGB
Natural Gas Conversion Kit
Materials Required:
(not supplied)
• 12 ft. to 15 ft. max. flexible hose with 3/8"
flare end (corrugated stainless steel
preferred).
• Pipe wrench
• Pipe threading compound
• Manual gas shut-off valve
• Appropriate length of gas line to reach the
permanent installation location with a 3/8"
flare end.
• Flat blade screwdriver
Note: Optional ZX144HKY quick disconnect hose for natural gas is
available to reach a 144" connection.
The installation of this grill must conform
with local codes or, in the absence of local
codes, with the National fuel gas code, ANSI
Z223 latest edition. Installation in Canada
must be in accordance with the Standard CAN
1-b149-1 and/or .2 (installation code for gas
burning appliances and equipment) and local
codes.
Operating pressure is 4" W.C.
Supply pressure should be 5" to 14" W.C. If
pressure is more than 14" W.C. a step down
regulator is required.
Installer
Supplied
TUBING
(3/8" FLARE)
Adapter 1/2 NPT
to 3/8" Flare Fitting
1/2 NPT Close Nipple
Natural Gas 4.0" Regulator
1/2 NPT Close Nipple
Installer Supplied
Shut-Off
Natural Gas Supply
Advertisement
Table of Contents
