Fujitsu AUU9RLF Design & Technical Manual page 96

8) Indoor room temperature sensor switching function
(Only for Wired remote controller)
The following settings are needed when use the control by Wired remote controller
temperature sensor.
Setting description
No
Yes
* If setting value is "00" :
Room temperature is controlled by the indoor unit temperature sensor.
* If setting value is "01" :
Room temperature is controlled by either indoor unit temperature sensor or remote controller
unit sensor.
9) Remote controller signal code
Change the indoor unit Signal Code, depending on the remote controllers.
Setting description
A
B
C
D
10) External input control
"Operation/Stop" mode or "Forced stop" mode can be selected.
Setting description
Operation/Stop mode
(Setting forbidden)
Forced stop mode
( ... Factory setting)
Function number Setting value
00
42
01
( ... Factory setting)
Function number Setting value
00
01
44
02
03
( ... Factory setting)
Function number Setting value
00
46 01
02
- (01 - 92) -