Fujitsu AUU9RLF Design & Technical Manual page 85

REMOTE CONTROLLER SIGNAL CODE SETTING
In function setting, please change to the setting that signal code setting of Wireless remote
controller is the same as indoor unit according to the following content when you change signal
code setting of indoor unit.
1. Press the START/STOP button until only the
clock is displayed on the remote controller
display.
3. Press the SET TEMP. "
to change the signal code between A→B→C
→D.
● If no buttons are pressed within 30 seconds after the signal code is displayed, the system
returns to the original clock display. In this case, start again from step 1.
● The air conditioner signal code is set to A prior to shipment.
● The remote controller resets to signal code A when the batteries in the remote controller
are replaced. If you use a signal code other than signal code A, reset the signal code after
replacing the batteries. If you do not know the air conditioner signal code setting, try each of
the signal codes (A→B→C→D) until you find the code which operates the air conditioner.
2. Press the MODE button for at least five
seconds to display the current signal code
(initially set to A).
" or the " " button 4. Press the MODE button again to return to
the clock display. The signal code will be
changed.
- (01 - 81) -