Disassembling The Paper Support Block Assembly - Epson fx-2180 Service Manual

FX-2180 Service Manual

4.2.11.2 Disassembling the Paper Support Block Assembly

1. Remove the E-ring fixing the paper feed roller shaft to the right CSF
frame.
Remove two CTBS (3 × 8) screws securing the paper support shaft to
2.
both right and left CSF frame.
Figure 4-48. Removing E-ring and Screw
3. Remove both paper support assemblies along with the paper feed roller
shaft and paper support shaft.
4. Remove the paper feed shaft from both paper support assemblies by
pulling them toward the right or left side.
5. Remove both paper feed roller from the paper support assemblies.
6. Remove both CSF roller cover by releasing the clips fixing them to the
paper support assemblies.
7. Remove the paper support shaft by pulling out it toward the right or left
side.
Rev. A
Figure 4-49. Removing the Paper Feed Roller Covers
8. Remove the paper holder sliding it along the paper support shaft, and
then remove the paper holder spring from the paper holder.
CHECK POINT
Be careful to assemble the paper feed roller into
the proper side of the paper feed roller shaft.
Because, The right and left rollers are not
interchangeable each other.
Disassembly and Assembly
4-32