Epson fx-2180 Service Manual page 66

FX-2180 Service Manual
CHECK POINT
Insert the 2 oil pads into the proper position in the
CR assembly, as shown in the following figure;
Figure 4-31. Installing the Oil Pad in the CR Assembly
Rev. A
T T
CHECK POINT
If remove the rear CR guide shaft along the CR
assembly once, be sure to reinstall the rear CR
guide shaft in the printer mechanism.
T T
The rear CR guide shaft has been a drilled
through hole near the right edge, and one side
of the hole has a chamfered edge. This edge
should be up, as shown in the following figure;
Figure 4-32. Assembling the Rear CR Guide Shaft
$'-8670(17
Adjust the Bi-directional print alignment. (Refer to
chapter 4.)
Disassembly and Assembly
4-23