Disassembling The Paper Support Block Assembly - Epson 2070 - LQ B/W Dot-matrix Printer Service Manual

Disassembly and Assembly
3.3.2 Disassembling Paper Support Block Assembly
1. Remove the CSF gear cover. Refer to step 1 in Section 3.3.1.
2. Remove the stepping motor. Refer to steps 2 and 3 in the Section 3.3.1.
3. Remove the E-ring fixing the right edge of the paper feed shaft.
4. Remove 1 gear (29 mm) from the right edge of the paper feed shaft.
5. Remove the paper feed shaft by pulling it toward the right side.
Remove the CPB tight (3 × 8) screw securing the paper support shaft to the right CSF frame, as
6.
shown in the following figure.
Figure 3-43 Removing the CBP Tight (3 X 8) Screw
3-28
Figure 3-41 Removing the E-ring
Paper Feed Shaft
Figure 3-42 Removing 1 Gear (29 mm)
Paper Support Shaft
LQ-2070 Service Manual
Gear(29 mm)
CPB tight Screw (3X8)
Rev.A