Running Mfglite; Table 3-16 Mfglite Parameters - Fujitsu stylistic lt Reference Manual

Running MFGLITE

MFGLITE is a command-line utility that allows you to configure BIOS Setup options and other options
such as access to individual BIOS Setup menus. (Note that in addition to running MFGLITE at the
command line as described here, you can run MFGLITE from a batch file to configure BIOS options to
desired settings.)
To run MFGLITE attach a keyboard and floppy disk drive to your system and perform the following
procedure. (An external keyboard must be used to type MFGLITE commands since pen support is not
available for MFGLITE.) It may be necessary to download the MFGLITE utility from the FPSI web site,
www.fpsi.fujitsu.com.
1. Start your system from a bootable diskette.
2. Type the command MFGLITE followed by the desired parameters using the following syntax,
MFGLITE [option=setting]
where option and setting are the mnemonic symbols for the desired MFGLITE parameters listed in
Table 3-16. (Brackets indicate that the parameter is optional.) You can specify several parameters on
the same command line. To do so, place a comma between each parameter. (Do not exceed the
maximum MS-DOS command line length of 127 characters, including spaces.) For example, the
following command sets the display device to LCD and turns the speaker off.
MFGLITE DISP=LCD, SPK=N
3. When all desired options and settings are typed on the command line, press Enter to run MFGLITE.
When the MFGLITE command is complete, the following message is displayed.
Configuration complete.
Table 3-16 lists MFGLITE parameters and the BIOS settings that they configure. These BIOS options are
the same as those described earlier for BIOS Setup. Refer to "BIOS Setup" earlier in this chapter for
detailed descriptions of corresponding BIOS options listed in this table.
Option Symbol Setting Symbol
QKBT N
Y
DIAG N
Y
PRMT N
Y
NLOK A
Y
N

Table 3-16 MFGLITE Parameters

Setting Description
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
Auto
On
Off
Option Description
QuickBoot Mode
Boot-time Diagnostic
Messages
Setup Prompt
Numlock
Running MFGLITE
3
3-21