Makita DLS713 Instruction Manual page 10

Switch action
For European countries
3
2
011266
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
push the lever up, press in the lock-off button and then
pull the switch trigger. Release the switch trigger to stop.
WARNING:
Before installing the battery cartridge on the
•
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released. Do not pull the switch
trigger hard without pressing in the lock-off
button. This can cause switch breakage.
Operating a tool with a switch that does not actuate
properly can lead to loss of control and serious
personal injury.
A hole is provided in the switch trigger for insertion of a
padlock to lock the tool off.
For all countries other than European countries
1
2
011243
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
Before installing the battery cartridge on the
•
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released. Do not pull the switch
trigger hard without pressing in the lock-off
button. This can cause switch breakage.
Operating a tool with a switch that does not actuate
properly can lead to loss of control and serious
personal injury.
1. Lever
4
2. Switch trigger
3. Lock-off button
4. Hole for padlock
1
1. Lock-off button
2. Switch trigger
3. Hole for padlock
3
A hole is provided in the switch trigger for insertion of a
padlock to lock the tool off.
WARNING:
Do not use a lock with a shank or cable any
•
smaller than 6.35 mm (1/4") in diameter. A
smaller shank or cable may not properly lock the
tool in the off position and unintentional operation
may occur resulting in serious personal injury.
NEVER use tool without a fully operative
•
switch trigger. Any tool with an inoperative switch
is HIGHLY DANGEROUS and must be repaired
before further usage or serious personal injury may
occur.
For your safety, this tool is equipped with a lock-off
•
button which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the
lock-off button. A switch in need of repair may result
in unintentional operation and serious personal
injury. Return tool to a Makita service center for
proper repairs BEFORE further usage.
NEVER defeat the lock-off button by taping down or
•
some other means. A switch with a defeated
lock-off button may result in unintentional operation
and serious personal injury.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
the battery cartridge is
working on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury.
Hex wrench storage
012595
The hex wrench is stored as shown in the figure. When
the hex wrench is needed it can be pulled out of the
wrench holder. After using the hex wrench it can be
stored by returning it to the wrench holder.
10
removed
1. Wrench holder
2. Hex wrench
2
1
before