Table of Contents
Advertisement
To install the PA-4000 Series in a grounded 19-inch rack:
1.
Screw the rack mounting brackets onto the front or midpoint of the unit using a Phillips head
screwdriver.
2.
Lift the device and position it in the rack. It is recommended that two people perform this function.
3.
Align the mounting holes on the side of the device with holes in the rack rail. Make sure that rack
rail holes are selected so that the PA-4000 Series is level.
4.
Insert mounting screws into the aligned holes. Tighten with a Phillips screwdriver.
Connecting Cables to the Device
Figure 5 shows the cable connections of the PA-4050 and PA-4020. Refer to Table 1 for descriptions of
the front panel interfaces.
CAUTION:
certified.
Figure 5. Cable Connections for the PA-4050 and PA-4020
Palo Alto Networks
Fiber Transceivers that are installed by the user shall be Class I and CDRH
Network
Serial
Connecting Cables to the Device
SFP
HA1
Management
Installing the Hardware • 11
HA2
Advertisement
Table of Contents
