Tc2; General Characteristics; General Characteristics Wm - Electrolux TC2 Service Manual

5 TC2

5.1

GENERAL CHARACTERISTICS

The ENV06 electronic control system consists of a
single PCB, which incorporates the power, control
and display functions where the LCD display is
connected and the programme selector is
incorporated in the board.
The PCB is mounted on a casing fitted to the control
panel.
5.1.1

General characteristics WM

Version
TC2 (TIME MANAGER)
Version
TC2 (PROPORTIONAL)
No. buttons
No. of LEDs
Programme selector
Serial port
Power supply voltage
Washing type
Rinsing system
Motor
Spin speed
Anti-unbalancing system
Water fill
Detergent dispenser
Control of water level in the
tub
Door safety interlock
Heating element heat output
Temperature control
Buzzer
Sensors
SOI/DT 2010-03 dmm
maximum 8 (5 options + 1 start/pause + 2 for time driven)
maximum 2 + LCD display
15-21 positions with main switch (incorporated in the PCB)
DAAS-EAP communication protocol up to 115,200 baud
220/240V
50/60 Hz (configurable)
Traditional with "Eco-ball" sphere
Jet-System
Traditional with "Eco-ball" sphere
Jet-System
Collector, with tachometric generator (Universal)
Two-pole asynchronous, with three-phase tachometric generator (with
Inverter)
600 ÷ 1,600 rpm
FUCS (for universal motors)
AGS (for asynchronous motors with Inverter)
1 solenoid valve with 1 inlet – 2 or 3 outlets
3 compartments: pre-wash/stains, wash, conditioner
4 compartments: pre-wash, wash, conditioner, (bleach)
Electronic/analogue pressure switch
Traditional (with PTC)
Instantaneous
1950W with thermal fuse incorporated
NTC sensor incorporated in the heating element
Traditional incorporated in the PCB
Water fill gauge (flowmeter)
Aqua control
23/78
599 72 84-41