Additional Information; Troubleshooting - Sony DVP-NS900V Operating Instructions Manual

Additional Information

Troubleshooting

If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist, consult your nearest
Sony dealer.
Power
The power is not turned on.
, Check that the power cord is connected
securely.
Picture
There is no picture.
, The connecting cords are not connected
securely.
, The connecting cords are damaged.
, The player is not connected to the correct TV
input jack (page 20).
, The video input on the TV is not correctly set.
, You have pressed VIDEO ON/OFF (or
VIDEO OFF) (page 37).
, You have selected "PROGRESSIVE" in
"COMPONENT OUT" even though your TV
cannot accept the signal in progressive format.
In this case, set the COMPONENT VIDEO
OUT/SCAN SELECT switch on the back
panel of the player to INTERLACE. Then set
"COMPONENT OUT" to "INTERLACE"
after you can see the TV screen correctly, and
reset COMPONENT VIDEO OUT/SCAN
SELECT switch to SELECTABLE.
Picture noise appears.
, The disc is dirty or flawed.
, If the picture output from your player goes
through your VCR to get to your TV, the copy-
protection signal applied to some DVD
programs could affect picture quality. If you
still experience problems even when you
connect your player directly to your TV,
94
please try connecting your player to your TV's
S video input (page 20).
, You have selected "PROGRESSIVE" in
"COMPONENT OUT" even though your TV
cannot accept the signal in progressive format.
In this case, set the COMPONENT VIDEO
OUT/SCAN SELECT switch on the back
panel of the player to INTERLACE. Then set
"COMPONENT OUT" to "INTERLACE"
after you can see the TV screen correctly, and
reset COMPONENT VIDEO OUT/SCAN
SELECT switch to SELECTABLE.
, Even if your TV is compatible with
progressive format (480p) signals, the image
may be affected when you set
"COMPONENT OUT" to "PROGRESSIVE."
In this case, set "COMPONENT OUT" to
"INTERLACE."
Even though you set the aspect ratio
in "TV TYPE" of "SCREEN SETUP,"
the picture does not fill the screen.
, The aspect ratio of the disc is fixed on your
DVD.
Sound
There is no sound.
, The connecting cord is not connected securely.
, The connecting cord is damaged.
, The player is connected to the wrong input
jack on the amplifier (receiver) (page 25, 27,
29).
, The amplifier (receiver) input is not correctly
set.
, The player is in pause mode or in Slow-motion
Play mode.
, The player is in fast forward or fast reverse
mode.
, If the audio signal does not come through the
DIGITAL OUT (OPTICAL or COAXIAL)
jack, check the audio settings (page 89).
, SACD audio signals are not output from the
digital jack.