Sony DVP-NS900V Operating Instructions Manual page 89

DOLBY
Select this when the player is
SUR-
connected to an audio component
ROUND that conforms to Dolby Surround
(Pro Logic). The output signals
which reproduce the Dolby
Surround effect are downmixed to
2 channels.
NORMAL
Select this when the player is
connected to an audio component
that does not conform to Dolby
Surround (Pro Logic). All of the
output signals are downmixed to 2
channels without the Dolby
Surround (Pro Logic) effect.
xDIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)
jack.
ON Normally select this position. When you
select "ON," set "DOLBY DIGITAL,"
"DTS," and "48kHz/96kHz PCM." For
details on setting these items, see
"Setting the digital output signal."
OFF
The player does not output the audio
signals via the DIGITAL OUT
(OPTICAL or COAXIAL) jack. The
influence of the digital circuit upon the
analog circuit is minimal.
Note
SACD audio signals are not output from the digital
jack.
Setting the digital output signal
Switches the method of outputting audio
signals when you connect the following
component using an optical or a coaxial
digital cord via the DIGITAL OUT
(OPTICAL or COAXIAL) jack.
— Amplifier (receiver) with digital input
jack
— Amplifier (receiver) with a built-in DTS or
DOLBY DIGITAL decoder
— MD or DAT deck
For connection details, see page 23.
Select "DOLBY DIGITAL," "DTS," and
"48kHz/96kHz PCM" after setting "DIGITAL
OUT" to "ON."
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
48kHz/96kHz PCM:
xDOLBY DIGITAL (DVD VIDEO/DVD-
RW only)
Selects the Dolby Digital signals to be output
via the DIGITAL OUT (OPTICAL or
COAXIAL) jack.
D-PCM
Select this when the player is
connected to an audio component
lacking a built-in Dolby Digital
decoder. You can select whether
the signals conform to Dolby
Surround (Pro Logic) or not by
making adjustments to the
"DOWNMIX" item in "AUDIO
SETUP" (page 88).
DOLBY Select this when the player is
DIGITAL
connected to an audio
component with a built-in Dolby
Digital decoder.
If the player is connected to an
audio component lacking a built-
in Dolby Digital decoder, do not
set this. Otherwise, when you
play the Dolby Digital sound
track, a loud noise (or no sound)
will come out from the speakers,
affecting your ears or causing the
speakers to be damaged.
OFF
STANDARD
SHARP
DOLBY SURROUND
ON
D-PCM
D-PCM
48kHz/16bit
continued
89