More Options; Caring For Your Device - ResMed AirSense 10 User Manual

More options

Your care provider may have given you access to personalise a few more options.
Pressure Relief
SmartStart
Mask

Caring for your device

It is important that you regularly clean your AirSense 10 device to make sure you receive optimal
therapy. The following sections will help you with disassembling, cleaning, checking and
reassembling your device.
Disconnecting the air tubing
1. Hold the cuff of the air tubing and gently pull it away from the device.
2. Hold both the cuff of the air tubing and the swivel of the mask, then gently pull apart.
Cleaning
You should clean the device weekly as described. Refer to the mask user guide for detailed
instructions on cleaning your mask.
1. Wash the air tubing in warm water using mild detergent.
Do not wash in a dishwasher or washing machine.
2. Rinse the air tubing thoroughly and allow to dry out of direct sunlight and/or heat.
3. Wipe the exterior of the device with a dry cloth.
Checking
You should regularly check the air tubing and air filter for any damage.
1. Check the air tubing and replace it if there are any holes, tears or cracks.
2. Check the air filter and replace it at least every six months.
Replace more often if there are any holes or blockages by dirt or dust.
6
When Pressure Relief is enabled, you may find it easier to breathe out. This
can help you get used to therapy.
When SmartStart is enabled, therapy starts automatically when you breathe
into your mask. When you remove your mask, it stops automatically after few
seconds.
This option shows your mask type setting. If you use more than one type of
mask, adjust this setting when switching between masks.