Download Print this page

Lanzar VBD700 Instruction Manual page 6

Advertisement

20. CLOCK BUTTON
To view the current time, press the CLK button, where it will display for five
seconds and then revert to the current unit mode.
During the period when the time is displayed, pressing and holding the CLK
button until the HOUR flashes on the display, then press the + or - button to
adjust HOUR.
Then pressing and holding the CLK button again until the MINUTE flashes
on the display, then press the + or - button to adjust MINUTE.
21.SCAN BUTTON
Press the SCN button to scan the radio frequency. If a valid signal has detected,
the current frequency will be hold and blinked for 5 seconds, then press SCN
again to stop scan and remain the current frequency; otherwise, the radio will
go on to scan the other radio frequency five seconds later.
22. LOC BUTTON
Radio station search mode is divided by this LO/DX switch, this button can be
used to control an attenuator in the tuner during search. The detecting level
of seek, scan, auto-memory will be reduced as much as the attenuated level
of the tuner. In radio mode, press the LOC button to change local reception or
distance reception. Note: This button is only for FM reception. In AM mode,
LOC is void.
23. LOUDNESS BUTTON
When press shortly, the LOUD mode is turned on, its to enhance the bass
sound effect when the volume level is low. Press again to cancel the loudness
effect.
24. ST/MO BUTTON
In radio mode, press the ST briefly to select stereo or mono sound mode.
25. EJECT KEY
In the power on state, the loaded disc can be ejected by pressing the EJ key.
26. CD SLOT
27. FLASHING LED
When the front control panel is removed this indicator flashes.
28. RESET BUTTON
Before operating the unit for the first time, or after replacing the car battery or
changing the connections. You must reset the unit.
Press this button with a cuspidal object. This operation will erase the clock
setting and some stored contents.
Page 5
OPERATION OF REMOTE CONTROLLER:
Note:
Before using this remote controller, please make sure
turn on the device by pressing the power button on
the front control panel.
1. Power On/Off.
2. Mute Button
3.
Loudness Button
4. Level/MENU UP Button
5. SEL/MENU
Button
6. Level/MENU Down Button
7. MO/ST Button
8. A.P Button
9. Band Button
10. Mode Button
11.Tune/Seek Up And Track Skip Up/FF Button
12.Tune/Seek Down And Track Skip Down/REW Button
13. SCAN BUTTON
14. Clock Display /Setting Button
15. LOC/DX Button
16. CD Track TOP/
/Radio Preset 1
18. CD Track RPT/Radio Preset 3
20. Radio Preset 5
17. CD Track INT/Radio Preset 2
19. CD Track RDM/Radio Preset 4
21. Radio Preset 6
Page 6

Advertisement

loading