GE Standard Tub Owner's Manual page 9

Operation of models with cycle dial
Rinse Only
For rinsing partial loads that will be washed later. Do not use detergent.
1
Make sure HEATED DRY is not selected.
2
Be sure the door is unlatched.
Plate Warmer or Drying
For warming clean dishes and serving plates. This cycle will take approximately 39 minutes.
1
Load clean dishware to be warmed.
2
Select HEATED DRY ON.
3
Be sure the door is unlatched.
Hot Start or Hot Prestart Option
Preheats wash water.
1
Select the HOT START or HOT PRESTART
cycle and any other option on the push
button pad.
2
Be sure the door is unlatched.
Short Wash or Light Wash or Water Saver
For quickly washing loads of everyday dishes with light to medium soils that have not dried on.
1
Be sure the door is unlatched.
2
Slowly turn the Dial to SHORT WASH,
LIGHT WASH or WATER SAVER.
Start
(Models with a Dial)
Slowly turn the Dial to the START or ON position, or the selected cycle. Don't turn it past the START,
ON or cycle position; you could accidentally miss a prewash.
There is a time delay between start-up and water fill so you will not hear any wash action right
away.
Latch the door to begin the cycle.
3
Slowly turn the Dial to RINSE ONLY.
4
Latch the door to start the cycle.
4
Slowly turn the Dial to PLATE WARMER or
DRYING.
5
Latch the door to start the cycle.
3
Slowly turn the Dial to HOT START or
HOT PRESTART.
4
Latch the door to start the cycle.
3
Latch the door to start the cycle.
GEAppliances.com
9