VIA Technologies P4X266-PE11-L User Manual page 20

Hardware Installation
2.4 Jumper Settings for Wake-On-PS/2 Keyboard
Wake-On-PS/2 Keyboard - Jumper JP1
The Wake-On-PS/2 Keyboard function allows you to use the PS/2
keyboard to wake up the system from the S5 state. By default, JP1
is disabled. To use this function, set JP1 to 2-3 On. “PS2KB Wakeup
Select” (“Wake Up Events” field) in the Power Management Setup
submenu of the BIOS must be set accordingly. Refer to chapter 3
for details.
20
1 2 3
1-2 On: Disable - VCC
(default)
Warning:
1. If you forgot the password, you must power-off the system,
unplug the power cord and clear the CMOS data. Follow
the steps in the “Jumper Settings for Clearing CMOS Data”
section.
2. The 5VSB power source of your power supply must
support ≥ 720mA.
1 2 3
2-3 On: Enable - 5VSB