Operation Manual - Sharp 64LHP5000 Service Manual

64LHP5000
PROJECTOR UNIT
Front Panel Functions
A flip-down door conceals the control panel. Push gently
and release, to open the door. To close the door, lift it back
up into place.
NOTE:
If you accidentally pull the door, it may not shut properly. Push the
door back in to shut it.
1 2
POWER/
TIMER
DOWN LOAD
In some cases, the door may only open slightly when
pushed.
In such cases, open the door with your finger as shown in
the figure at left.
3 4
OPC
1 POWER/DOWNLOAD indicator
Lights when power is on. Flashes when downloading the
GUIDE Plus+ program information.
2 Timer indicator
Lights GUIDE Plus+ timer is set.
3 DTV indicator
Lights when receiving a digital television broadcast.
Flashes when downloading the DTV program information.
(DTV indicator may still blink even when the power has
been turned off. This is not a defect.)
4 OPC sensor
Sensor to detect the room brightness.
5 POWER button (STANDBY/ON)
Press once to turn on the Rear Projection HDTV. Press
again to turn off the Rear Projection HDTV.
NOTE:
When the Rear Projection HDTV is turned on in DTV mode, it may take
several seconds before the DTV image is displayed. This is not a
malfunction.
6 INPUT button
Press to select your program source. Each press of the
INPUT changes the selection to the next source.
TV DTV
INPUT 4 INPUT 3
7 CHANNEL buttons
Press plus ' or minus " to tune to a higher or lower
channel. Only the preset channels can be tuned in using
these buttons.
8 RETURN button
Press to set the Rear Projection HDTV to its initial mode.
5 6
POWER
STANDBY/ON
6
INPUT 1
INPUT 2
7 8
INPUT CH RETURN