Table of Contents
Advertisement
Initial mode
Input selector:
Set to TV.
TV channel:
Remains at the last channel set.
VOLUME:
Remains at the last setting.
MUTING:
OFF
VIDEO
MODE:
STD
Parameters:
Set to 0.
3D Y/C LEVEL:
3
3D NR LEVEL:
3
CNR:
OFF
FAV. COLOR:
STD.
FLESH TONE:
ON
AUDIO
MTS:
MAIN
Parameters:
Set to 0.
SURROUND:
OFF
VIEW
AUTO VIEW:
OFF
MODE:
SMART STRETCH
V. POSITION:
Set to 0.
CC:
OFF
OPC:
OFF
SYSTEM IN/OUT
SPEAKER:
NORMAL
AUDIO OUT:
FIXED
•
When this button is pressed while adjusting the
outer point convergence, the outer point
convergence returns to the initial mode.
9 VOLUME buttons
Press plus (+) button to increase the volume, press minus
(–) button to decrease it.
0 INPUT 4 jacks
These inputs are for Video Movie and VCR. Use RCA-type
pin plug cords (the same as those used in Hi-Fi systems)
and S-VIDEO cords for connections. When the audio
source to be connected is monaural, connect the source to
the L-(MONO) jack.
9
VOL
0
S-VIDEO
VIDEO
L-AUDIO-R
(MONO)
INPUT 4
7
CAUTION:
Do not press any operation button on the Rear Projection
HDTV or the remote control unit while recording. Signals
from the MONITOR OUTPUT jacks may be temporarily
interrupted when a button is pressed.
ATTENTION
The Rear Projection HDTV Receiver will not function
properly in the following cases.
•
An electrical discharge in the CRT.
•
Lightning storms.
•
High static electricity environment.
•
Poor voltage regulation in the power source.
If the Rear Projection HDTV does not operate properly,
reset it as follows:
1. Unplug the AC cord.
2. After approximately 1 minute, turn on the power with
switch and 5 POWER button.
NOTE:
On rare occasions, an electrical discharge may occur inside the
CRT. It makes a short, sharp pop and either no sound is produced
or the volume level changes by itself. The TWIN PICTURE and
SEARCH SCREEN function will be cancelled automatically if an
electrical discharge occurs when this function is engaged.
64LHP5000
PROJECTOR UNIT
FRONT PANEL FUNCTIONS
Advertisement
Table of Contents
