Programming Macro Keys; Programming A Macro Key - Universal Electronics Potenza ST User Manual

4. Perform the instructions under
"Programming Device Control" on page 9 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the ID Lock.
5. On the remote control, press STB once; it will
blink once. Then press and hold SETUP until
the STB key blinks twice.
Enter 9 8 2. The STB key will blink twice,
6.
indicating ID Lock is again locked.

PROGRAMMING MACRO KEYS

The Potenza ST Universal Remote Control includes two
macro keys (located directly below the MUTE and LAST
keys). Macro keys allow you to set up key macros to
activate certain keys in a specific order. For example, you
can set up a key macro to change the channels on your
TV, raise or lower the volume, and start recording on
your VCR, all with the touch of one key. If you want to
change the macros stored in a previously-programmed
macro key, you'll need to clear the key first (see
"Clearing a Macro Key" on page 21).

Programming a Macro Key

1. On the remote control, press and hold SETUP
until it blinks twice.
Enter 9 9 5. The SETUP key blinks twice.
2.
3. Select a macro key (for example, F1) and
press it once.
4. Press the key sequence you want to program
into the macro. For example, to turn on your
TV and raise its volume, press the TV mode
key once, followed by pressing the VOL+ key
once.
www.urcsupport.com
20