Table of Contents
Advertisement
Atlas OCAP M1056.fm Page 18 Wednesday, April 30, 2008 2:52 PM
4.
Perform the instructions under
"Programming Device Control" on page 10 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the cable ID Lock.
5.
On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice.
Enter 9 8 2. The CBL key will blink twice,
6.
indicating ID Lock is again locked.
PROGRAMMING MACRO KEYS
The Atlas OCAP 5-Device Remote Control includes two
macro keys (located directly below the MUTE and LAST
keys). Macro keys allow you to set up key macros to
activate certain keys in a specific order. For example, you
can set up a key macro to change the channels on your
TV, raise or lower the volume, and start recording on
your VCR, all with the touch of one key. If you want to
change the macros stored in a previously-programmed
macro key, you'll need to clear the key first (see
"Clearing a Macro Key" on page 19).
Programming a Macro Key
On the remote control, press and hold SETUP
1.
until it blinks twice.
2.
Enter 9 9 5. The SETUP key blinks twice.
3.
Select a macro key (for example, F1) and
press it once.
4.
Press the key sequence you want to program
into the macro. For example, to turn on your
TV and raise its volume, press TV followed by
VOL+.
www.urcsupport.com/atlasocap
18
Advertisement
Table of Contents
