IrDA Infrared Module Header: IR1
The connector allows you to connect to IrDA Infrared module. You must configure the
setting through the BIOS setup to use the IR function.
IR1
Wake On LAN Connector: JWOL
This connector allows you to connect to a LAN card with Wake On LAN function. You
can wake up the computer via remote control through a local area network.
MSI Reminds You...
To be able to use this function, you need a power supply that provides
enough power for this feature. (750 mA 5V Stand-by)
Wake Up On Modem Connector: JMR1
This connector allows you to connect to connect a modem card with Wake Up On
Modem function. You can wake up the computer via remote control device through
modem.
JMR1
IR1 Pin Definition
Pin
1
2
3
1
4
5
JWOL
1
5VSB
GND
MP_WAKEUP
JMR1 Pin Definition
Pin
1
1
2
3
4
5
Hardware Setup
Signal
VCC5
NC
IRRX
GND
IRTX
Signal
NC
GND
WAKE UP
NC
5VSB
2-23