Table of Contents
Advertisement
Getting started
Battery installation & charging
Install the battery as shown on the next page.
battery, the screen indicates the battery status (see table below). If necessary,
place the handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the charger when not in use. The
battery is fully charged after 16 hours of continuous charging. See the table
on page 82
for battery operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. The screen shows LOW BATTERY and the backlight is off
until you have charged the battery without interruption for at least one hour.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators
The screen is blank.
The screen shows
PLACE IN CHARGER
and
flashes.
The screen shows
LOW BATTERY and
flashes.
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
Battery status
Battery has no charge
and the handset
cannot be used.
Battery has very little
charge and the handset
cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
9
Once you have installed the
Action
Charge without
interruption until the
screen shows LOW
BATTERY (at least 10
minutes).
Charge without
interruption until the
screen shows LOW
BATTERY (at least four
minutes).
Charge without
interruption until the
screen shows HANDSET
X (at least one hour).
To keep the battery
charged, place it in
the telephone base or
charger when not in use.
Advertisement
Table of Contents
