Getting started
Telephone base installation
Install the telephone base as shown below. Make sure that the electrical outlet
is not controlled by a wall switch.
The telephone base is set for desktop use. If you want to change to the wall
mounting position, install the supplied wall mount bracket to the telephone base.
See pages 11-13 for details.
1. Plug the small
end of the power
adapter into the
power jack at
the bottom of
the telephone
base.
7. Raise the antenna.
Power
adapter
6. Plug the large end of the
power adapter into a power
outlet not controlled by a
wall switch.
If you want to change to the wall
�. Route the power cord through the
slot next to the telephone jack.
Telephone
line cord
DSL filter (not included),
required if you have DSL
high-speed Internet service.
7
�. Plug one end of
the telephone
line cord into the
telephone jack at
the bottom of the
telephone base.
4. Place the cords
into the channels.
5. Plug the other
end of the
telephone line
cord into a
telephone jack
or a DSL filter.