Table of Contents
Advertisement
PARTS NAMES
1
1
3
2
4
2
3
4
5
2
3 2
1
1
1
Shorter screws: M3 x 4
2
Longer screws: M3 x 6
3
Camera mounting
screw hole:
1/4"-20 UNC
3
English
1
Lens iris output connector (4 pin)
This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.
2
Flange-back adjustment lever (See page 6)
3
Flange-back lock screw
4
Lens mount cap
The cap is installed to protect the lens mount section.
Remove the lens mount cap before installing a lens (sold separately).
5
Camera installation bracket
The bracket can be fixed at the top or bottom of the camera. When fixing the bracket, be sure to use the
longer screws and install the shorter screws on the opposite side to seal the openings.
CAUTION:
When installing the camera support, select a location that can support the total weight of the
camera and accessories.
Advertisement
Table of Contents
