LK Systems ICS.2 Assembly Instructions Manual page 5

10
Hold the L button in until the L light is solid
green on the receiver that the room thermostats
are to undergo the learning process for.
This step prepares the receiver for learning of
the room thermostats.
11
Press and hold SET in until the display shows
MATE on the room thermostat that is to under-
go the learning process.
Assembly instructions | LK Room Temperature Control ICS.2
12
The L light changes to orange and the channel
lights change to green.
Choose the channel/channels that the room
thermostat is to control by pressing the corre-
sponding channel button (1 - 8). The selected
channels flashes green.
Channels already occupied have a solid orange
light.
13
The selected channels are displayed in the room
thermostat display (1 - 8). Once all the required
channels have finished the learning process,
you confirm by pressing the SET button once.
The display will then show SYNC to show that
it is synchronised with the receiver (this may
take a while).
If the room thermostat takes a long time to
synchronise, this synchronisation process can
be restarted by pressing the SET button once.
EN.33.C.152.1405
5