LK Systems ICS.2 Assembly Instructions Manual page 17

Week program – adaptive function
The system has an adaptive function which
means that the system learns the level of thermal
inertia in the room and adjusts the start time to
ensure the temperature is reached at the required
start time (from Economy to Comfort).
The unit comes with a disabled adaptive func-
tion, the function is enabled as follows:
1. Press Set until
2. Press the right arrow until AdPt (Adaptive)
appears in the display, confirm with Set.
3. Select ON/OFF using the right/left arrow,
confirm with Set.
The function starts following the next change
from Economy to Comfort.
NOTE:
The above setting only applies to that specific room/ther-
mostat.
Week program - disconnect the program
temporarily
If you prefer, you can disconnect the week pro-
gram temporarily or the individual room ther-
mostat using any room thermostat.
The week program is temporarily removed as fol-
lows:
1. Increase/decrease the temperature using
the right/left arrow.
2. The temperature starts to flash.
3. The temporary increase/decrease is enabled
when the temperature stops flashing.
4. The display shows neither Comfort or Econ-
omy when the temporary increase/decrease
is enabled.
The temporary disconnection of the week pro-
gram disappears when the program switches be-
tween Economy/Comfort next time.
Alternatively, press Set for 5 seconds to return to
the week program.
flashes, confirm with Set.
Assembly instructions | LK Room Temperature Control ICS.2
System clock
The unit is fitted with a system clock. In order
for the week program to work, the unit's system
clock must be set. This can be performed from
any thermostat in the system. The set time ap-
plies to all room thermostats in the system.
Set the system clock as follows:
1. Press Set until
2. Press the right arrow until SySc (System Clock)
appears in the display, confirm with Set.
3. Hours/minutes flashes, set the time by us-
ing the right/left arrow, confirm with Set.
4. Weekday starts flashing, select using the
right/left arrow, (1 = Mon, 7 = Sun) confirm
with Set.
Set year and date as follows:
1. Press Set until
2. Press the right arrow until SYSD (System
Date) appears in the display, confirm with Set.
3. Year flashing, set the Year by using the
right/left arrow, confirm with Set.
4. Month flashing, set the Month by using the
right/left arrow, confirm with Set.
5. Date flashing, set the Date by using the
right/left arrow, confirm with Set.
flashes, confirm with Set.
flashes, confirm with Set.
EN.33.C.152.1405
17