LK Systems ICS.2 Assembly Instructions Manual page 16

Assembly instructions | LK Room Temperature Control ICS.2
Week program.
The unit is fitted with a week program. The week
program switches between either Comfort (day
temperature) or Economy (night setback). The
times for each temperature can be set as stated
in the options below. The system can also adjust
the start time to ensure that the correct tempera-
ture is reached at the right time with the adaptive
function connected (self-learning). As standard,
the week program is disabled upon delivery.
Week program – enable
The week program is enabled as follows:
1. Press Set until
2. Press the right arrow until WKPG (Week
Program) appears in the display, confirm
with Set.
3. Select ON/OFF using the right/left arrow,
confirm with Set.
4. Repeat the above for the other room thermo-
stats that are to follow the week program.
NOTE:
The system clock must be set correctly for this function to
work properly.
Week program – weekday/weekend
The unit can handle either a program for all days
of the week (1-7) or a program for weekdays &
weekends (1-5/6-7).
Select the program as follows:
1. Press Set until
2. Select WKMD (Week Mode) using the
right/left arrow, confirm with Set.
3. Select either 1-7 or 1-5/6-7 using the right/
left arrow, confirm with Set.
The above setting applies to the individual room
thermostat.
EN.33.C.152.1405
16
flashes, confirm with Set.
flashes, confirm with Set.
Week program – temperature
The units are supplied with the following values
as default:
Comfort = 20 °C
Economy = 18 °C
Change temperatures as follows:
1. Press Set until
2. Select Eco for night setback temperature,
confirm with Set.
3. The temperature flashes, change the tem-
perature using the right/left arrow, confirm
with Set.
Repeat the above but select Comfort for day tem-
perature.
NOTE:
The above setting only applies to that specific room/
thermostat. If you want the same temperature for all room
thermostats, repeat the above steps for the other room
thermostats.
Week program – start/stop times
The unit can handle two events per day, i.e. the
time the unit is to switch between day (Comfort)
and night (Economy).
Follow these steps to set the time:
1. Press Set until
2. Select WKEV (Week Event) using the right/
left arrow, confirm with Set.
3. The time to start 1 of Economy flashes, set
the required time using the right/left arrow,
confirm with Set.
4. The time to stop 1 of Economy flashes, set
the required time using the right/left arrow,
confirm with Set.
5. The time to start 2 of Economy flashes, set
the required time using the right/left arrow,
confirm with Set.
6. The time to stop 2 of Economy flashes, set
the required time using the right/left arrow,
confirm with Set.
The above setting applies to the individual room
thermostat.
flashes, confirm with Set.
flashes, confirm with Set.