Basic Troubleshooting - Pride Mobility LEGEND XL Owner's Manual

V I I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and can
no longer hold a charge.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed
below develops.
NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off, then turned back on.
Flash Code
(1)
(2)
(3)
(6)
(7)
(8)
(9)
(10)
What if all the systems on my scooter seem to be "dead"?
Make certain that the key is in the "on" position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. "Your Scooter ."
Make certain that both T-handle battery harnesses are firmly connected to the rear section and to the
battery terminals. See VII. "Disassembly and Assembly."
Make sure that the front-to-rear harness is firmly connected to the rear section. See VII. "Disassembly
and Assembly."
Be sure the power down timer feature hasn't been activated. See V. "Operation."
Check the 3-amp fuse located on the lower portion of the tiller console. See IX. "Care and Mainte-
nance" for fuse replacement.
36
Condition
Battery voltage is too low to operate the
scooter or the charger is operating.
Motor disconnected.
Motor wiring fault.
Scooter is operating with the charger
attached.
Throttle trip. Throttle potentiometer fault
or speed potentiometer fault.
Internal controller fault.
Brake fault - your scooter was left in free-
wheel mode.
High battery voltage. The batteries have
been overcharged and the scooter won't
run.
www.pridemobility.com
Solution
Charge batteries or unplug the charger power cord
from the electrical outlet.
Check all connections to the motor.
Call your authorized Pride Provider for assistance.
Unplug the charger power cord from the off-board
charger port.
Call your authorized Pride Provider for assistance.
Call your authorized Pride Provider for assistance.
Turn the scooter key to the "off" position, then push
the manual freewheel lever to the drive position, and
restart your scooter.
Leave the scooter turned on to drain the batteries to
a sufficient level. If the batteries continue to over-
charge, call your authorized Pride Provider for assis-
tance.
Legend XL