Pride Mobility LEGEND XL Owner's Manual page 35

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 18.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section. See
figure 18.
WARNING!
harness so it will not become pinched
between the frame halves when pivoting
the rear sectionforward. See figure 19.
3. Holding the seat post, slowly pivot the rear section
forward until the curved locking brackets are fully
connected onto the top rear pegs. See figure 16.
4. Raise the tiller.
5. Latch the toggle latch. See figure 15A.
Lower the toggle latch buckle.
Push back on the toggle latch so it locks into place.
6. Reinstall the batteries into the battery wells and
reconnect the battery strap.
7. Connect the front-to-rear harness and both T-handle
battery harnesses.
8. Reinstall the shroud.
9. Reinstall the seat and secure it into place.
Legend XL
Position the front-to-rear
www.pridemobility.com
PEG
CURVED LOCKING BRACKET
FRONT-TO-REAR HARNESS
Figure 18. Frame Sections
35