Pride Mobility LEGEND XL Owner's Manual page 20

WARNING! If the key is moved to the "off" position while your scooter is in motion, the
electronic brakes engage and your scooter will come to an abrupt stop!
Status LED
The status LED alerts you to electrical problems that may occur with the scooter. The LED remains con-
stantly lit while your scooter is on. If your scooter develops an electrical problem, the status LED will flash
a code. See X. "Basic Troubleshooting" for flash codes.
Lights Switch
This switch controls the lights on your scooter.
Toggle the switch forward to turn on the rear running lights, front (upper) light, and front (lower) lights.
Toggle the switch to the middle to turn off all lights.
Toggle the switch rearward to turn on the rear running lights and front (lower) lights.
WARNING! Scooter users are required to use their lights when visibility is restricted—
day or night.
Speed Adjustment Dial
This dial allows you to preselect and limit your scooter's top speed.
The image of the tortoise represents the slowest speed setting.
The image of the hare represents the fastest speed setting.
Throttle Control Lever
This lever allow you to control the forward speed and the reverse speed of your scooter up to the maximum
speed you preset with the speed adjustment dial.
Place your right hand on the right handgrip and your left hand on the left handgrip.
Use your right thumb to push the right side of the lever to disengage your scooter's brakes and move forward.
Release the lever and allow your scooter to come to a complete stop before pushing the other side of the lever
to move in reverse.
When the throttle control lever is completely released, it automatically returns to the center "stop" position
and engages your scooter's brakes.
Half/Full Speed Switch
Toggle the switch forward (Full) and your scooter's maximum speed is 5.8 mph (9.33 km/h).
Toggle the switch rearward (Half) and your scooter's approximate maximum speed is 2.9 mph (4.67 km/h).
Tiller Console Fuses
These fuses help protect your scooter's front
lighting, turn signals, and key switch console
systems from receiving an overload of electrical
current. The fuses used in your scooter are the
same type used in automobiles. See figure 5A.
See XI. "Care and Maintenance" for fuse
replacement.
20
I I I . Y O U R S C O O T E R
www.pridemobility.com
5
1
1
1
1
Figure 5A. Tiller Console Fuses
B+
RIGHT RUNNING LIGHT
LEFT RUNNING LIGHT
LEFT TURN SIGNAL
RIGHT TURN SIGNAL
Legend XL