Skip Over Perforation - Epson FX-880 User Manual

Default-setting mode 1
Setting

Skip over perforation

Auto tear off
Auto line feed
Print direction
Software
I/F mode
Auto I/F wait time
0 slash
High speed draft
Input buffer
Buzzer
Auto CR (IBM 2380 Plus)*
IBM character table (IBM 2380 Plus)*
* This setting is available only in IBM 2380 Plus emulation mode.
Skip over perforation
This feature is available only when continuous paper is
selected. When you turn on this feature, the printer provides a
one-inch (25.4 mm) margin between the last line printed on one
page and the first line printed on the next page. Because most
application program margin settings override margin settings
from the control panel, you should use this setting only if you
cannot set your top and bottom margins using your application.
Auto tear-off
When auto tear-off is on and you are using continuous paper
with the front or rear push tractor, the printer automatically
advances the paper perforation to the tear-off position, where
you can easily tear off the printed page(s). When the printer
receives data again, it automatically moves the paper back to
the top-of-form position and starts printing, so you can use all
of the next page.
5-4
Changing Printer Settings From the Printer's Control Panel
Options
Off, On
Off, On
Off, On
Bi-D, Uni-D
ESC/P, IBM 2380 Plus
Auto, Parallel, Option
10 seconds, 30 seconds
0, 0
Off, On (10 cpi), On (12 cpi)
Off, On
Off, On
Off, On
Table 2, Table1