Epson FX-880 User Manual page 77

4. Slide the left sprocket approximately 12 mm (0.5 inches) from
the far left position and push the lever back to lock it in place.
Then slide the right sprocket to match the width of your
paper, but do not lock it. Move the paper support midway
between the two sprocket units.
12 mm (0.5 inches)
5. Make sure your paper has a clean, straight edge. Then open the
sprocket covers.
Note:
Make sure the printer is off before loading paper. If you insert the
paper while it is on, paper may jam in the printer.
6. Insert the paper into the front or bottom paper slot as described
below until it emerges between the platen and the ribbon guide.
Then pull up the paper until the perforation between the first
and second pages is even with the top of the printer's ribbon.
Before you load paper in the
front slot, remove the front
cover. Then load paper
printable side up.
Printing on Continuous Paper
3
3-23