Inserting The Batteries; Operating Range Of The Remote Control Unit - Denon PMA-1500AE Operating Instructions Manual

ENGLISH

Inserting the batteries

The accessory remote control unit is used to control the amplifier
from a convenient distance.
q
Remove the battery cover on the remote control unit.
w
Insert two dry cell batteries as shown in the diagram on the
battery supply unit.
e
Replace the battery cover.
Notes on battery usage
• RC-1022 uses the size R03 (AAA) dry cell batteries.
• The batteries will need to be replaced approximately once a
year. This will depend upon how often the remote control
unit is used.
• If, in less than a year from the time new batteries were
inserted, the remote control unit fails to operate the
amplifier from a near-by position, it is time to replace the
batteries.
(The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.)
• Insert the batteries properly, following the polarity diagram
inside the battery compartment.
• Batteries are prone to damage and leakage. Therefore:
• Do not mix new batteries with used ones.
• Do not mix different types of batteries.
• Do not jumper opposite poles of the batteries, expose
them to heat, break them open, nor expose them to
open fire.
• If the batteries have leaked, remove any traces of battery
fluid from the battery compartment wiping thoroughly with
a dry cloth. Then insert new batteries.

Operating range of the remote control unit

Approx. 8 meters
• Operate the remote control unit while pointing it towards the
remote control sensor on the amplifier as shown in the
diagram on the left.
• The remote control unit can be used at distances up to about 8
meters in a straight line from the amplifier. This distance will
decrease if there are obstructions blocking the infra-red light
transmission or if the remote control unit is not directed
straight at the amplifier.
NOTE:
• Do not press the operating buttons on the amplifier and
the remote control unit at the same time. This will cause
misoperation.
• Operation of the remote control unit will become less
effective or erratic if the infrared remote control sensor on
the amplifier is exposed to strong light or if there are
obstructions between the remote control unit and the
sensor.
• In case you operate a VCR, TV or other components by
remote control, do not operate buttons on two different
remote control units at the same time. This will cause
misoperation.
Besides being able to operate the PMA-1500 AE pre-main-
amplifier with this remote control unit,
you can also operate a DENON CD player from this handy
remote control unit.
3
ENGLISH
30°
30°