Mitsubishi Electric CM33-TL User Manual page 31

Auto
Mode 0-4
IDE Primary Master/Slave UDMA and IDE Secondary Master/Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is selected, the
BIOS will select the best available option after checking your hard drive or CD-
ROM.
Auto
Disabled
Init Display First
This field is used to select whether to initialize AGP or PCI first when the sys-
tem boots.
AGP
PCI Slot
IDE HDD Bock Mode
Enabled
Disabled
Onboard FDD Controller
Enabled
Disabled
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Disabled
MAN-0CM33-001
3 AWARD BIOS SETUP UTILITY
The BIOS will automatically set the system according to your
hard disk drive's timing.
You can select a mode that matches your hard disk drive's
timing. Caution: Do not use the wrong setting or you will
have drive errors.
The BIOS will automatically detect the settings for you.
The BIOS will not detect these categories.
When the system boots, it will first initialize AGP.
When the system boots, it will first initialize PCI.
The IDE HDD uses the block mode. The system BIOS will
check the hard disk drive for the maximum block size the
system can transfer. The block size will depend on the type
of hard disk drive.
The IDE HDD uses the standard mode.
Enables the onboard floppy disk controller.
Disables the onboard floppy disk controller.
The system will automatically select an I/O address for the
onboard serial port 1 and disable serial port 2.
Allows you to manually select an I/O address for the onboard
serial port 1.
Disables the onboard serial port 1.
MC Series Computer Products
27