Initial Cleaning; Setting The Time; Daily Use - AEG BC3331302 User Manual

4.1 Initial cleaning

• Remove all accessories and removable
shelf supports (if applicable).
• Clean the appliance before first use.
Refer to the chapter "Care and
cleaning".

4.2 Setting the time

You must set the time before you
operate the oven.
When you connect the appliance to the
electrical supply or after a power cut, the
indicator for the Time of Day function
flashes.
Press the + or - button to set the correct
time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.

5. DAILY USE

WARNING!
Refer to the Safety chapters.
To use the appliance, push the knob.
The knob comes out.
5.1 Activating and
deactivating the appliance
1. Turn the knob for the oven functions
to an oven function.
The power indicator comes on while
the appliance operates.
To change the time, press
again and again until the indica-
tor for the Time of Day function
flashes. You must not set the Du-
ration or End
the same time.
4.3 Preheating
Preheat the empty appliance to burn off
the remaining grease.
1.
Set the function
mum temperature.
2. Let the appliance operate for one
hour.
3.
Set the function
mum temperature.
4. Let the appliance operate for ten mi-
nutes.
5.
Set the function
mum temperature.
6. Let the appliance operate for ten mi-
nutes.
Accessories can become hotter than
usual. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
2. Turn the knob for the temperature
to a temperature.
The temperature indicator comes on
while the temperature in the appli-
ance increases.
3. To deactivate the appliance, turn the
knob for the oven functions and the
knob for the temperature to the Off
position.
ENGLISH
7
function at
and the maxi-
and the maxi-
and the maxi-