Installation Section
Installation Instructions
SPECIFICATIONS
IMPORTANT NOTICE: These installation instructions are designed for use by qualified personnel only, trained
especially for installation of this type of heating equipment and related components.
The heater must be installed on a level surface consisting entirely of, or a combination of, noncombustible
materials such as steel, iron, brick, tile, concrete, slate, or plaster. Do not install on carpeting. The heater must be
installed to keep specific clearances on all sides for service and inspection.
This appliance is so designed that no special precautions are necessary to reduce operational noise levels.
OUTDOOR INSTALLATION
Stackless, applies to all
MiniMax 100 outdoor models
INDOOR INSTALLATION
Applies to all MiniMax 100
indoor models,
Draft hood stack diameter = 125 mm
Rev. A 2-4-2000
ON ON
COLD
COLD
HOT
HOT
OFF
POOL TEMP
POOL TEMP
Outdoor Installation
Indoor Installation
8
P/N 471438