Husqvarna FT900 Operator's Manual page 5

ASSEMBLY
UNPACK CARTON & INSTALL HANDLE
(See Fig. 2)
&
CAUTION: Be careful of exposed
staples when handling or disposing of
cartoning material.
iMPORTANT: WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOTTO STRETCH OR KINK CABLE(S).
• Cut cable ties securing handles.
• Slowly lift handle assembly up, route cable(s) as shown
and align handle holes with handle panel hole and slot.
• Loosely assemble hardware as shown. Be sure the
shorter (1" long) hex bolt is assembled in lower hole
of handle. Repeat for opposite side. Tighten all
hardware securely.
• Cut cable ties securing tiller to skid and remove tiller
from skid.
• Remove screws securing depth stake to skid and
discard the screws.
LOCK
NUT WASHER
TILLER
HANDLE
FLAT
WASHER
HEX BOLT
5/16-18X1-1/4"
HEX BOLT
5/16-18Xl"
CABLE(S]
TILLER
HANDLES
HANDLE
PANEL
BOLTS
INSTALL DEPTH STAKE ASSEMBLY
(See Fig. 3)
• Loosen nut '_'.
• Insert stake support between engine bracket halves
with stake spring down.
• Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten securely. Tighten nut '_'.
• Depth stake must move freely. If it does not, loosen
support bolt.
ENGINE BRACKET
HALVES
NUT "A"
DEPTH STAKE
SUPPORT
STAKE
SPRING
DEPTH
STAKE
HEX BOLTS,
LOCK WASHERS,
AND HEX NUTS
SUPPORT
BOLT
Fig. 3
HANDLE HEIGHT
• Handle height may be adjusted to better suit operator.
(See "HANDLE HEIGHT" in the Service and Adjust-
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better handle your
tilling conditions (See "TINE ARRANGEMENT" in the
Service and Adjustments section of this manual).
TIN E OPERATION
• Check tine operation before first use. (See "TINE OP-
ERATION CHECK" in the Service and Adjustments
section of this manual).
Fig. 2
5