Do you have a question about the T 350R and is the answer not in the manual?
Questions and answers
Peter Armstrong
May 28, 2025
What fuel does the Honda engine use?
1 comments:
Mr. Anderson
May 28, 2025
The Husqvarna T 350R engine uses gasoline as its fuel.
This answer is automatically generated
Ian Henderson
April 7, 2025
The large pulley will not stay on the shaft
1 comments:
Mr. Anderson
April 9, 2025
To fix the large pulley on the Husqvarna T 350R that will not stay on the shaft, follow these steps:
1. Turn off Power and Ensure Safety: Disconnect the spark plug wire or power source to prevent accidental startup.
2. Inspect the Shaft and Pulley: - Check the shaft for wear, damage, or missing keyways. - Inspect the pulley bore for wear or deformation. - Ensure the key (if used) is not damaged or missing.
3. Clean the Shaft and Pulley: - Remove any dirt, rust, or debris using a wire brush or sandpaper. - Ensure both surfaces are clean and dry.
4. Check Fastening Method: - If the pulley uses a set screw, ensure the screw is present and not stripped. - Tighten the set screw firmly against the flat side of the shaft. - If a keyway and key are used, align them properly before securing the pulley.
5. Use Thread Locker: - Apply a medium-strength thread locker (e.g., blue Loctite) to the set screw to prevent loosening.
6. Add a Retaining Clip or Collar: - If the pulley keeps slipping off, install a shaft collar or retaining clip on the outside of the pulley to hold it in place.
7. Replace Worn Parts: - If the shaft, pulley, or key is worn or damaged, replace the necessary parts.
8. Test the Repair: - Reconnect power and run the machine briefly to ensure the pulley stays in place.
If the pulley continues to come off after these steps, professional inspection may be necessary.
Need help?
Do you have a question about the T 350R and is the answer not in the manual?
Questions and answers
What fuel does the Honda engine use?
The Husqvarna T 350R engine uses gasoline as its fuel.
This answer is automatically generated
The large pulley will not stay on the shaft
To fix the large pulley on the Husqvarna T 350R that will not stay on the shaft, follow these steps:
1. Turn off Power and Ensure Safety: Disconnect the spark plug wire or power source to prevent accidental startup.
2. Inspect the Shaft and Pulley:
- Check the shaft for wear, damage, or missing keyways.
- Inspect the pulley bore for wear or deformation.
- Ensure the key (if used) is not damaged or missing.
3. Clean the Shaft and Pulley:
- Remove any dirt, rust, or debris using a wire brush or sandpaper.
- Ensure both surfaces are clean and dry.
4. Check Fastening Method:
- If the pulley uses a set screw, ensure the screw is present and not stripped.
- Tighten the set screw firmly against the flat side of the shaft.
- If a keyway and key are used, align them properly before securing the pulley.
5. Use Thread Locker:
- Apply a medium-strength thread locker (e.g., blue Loctite) to the set screw to prevent loosening.
6. Add a Retaining Clip or Collar:
- If the pulley keeps slipping off, install a shaft collar or retaining clip on the outside of the pulley to hold it in place.
7. Replace Worn Parts:
- If the shaft, pulley, or key is worn or damaged, replace the necessary parts.
8. Test the Repair:
- Reconnect power and run the machine briefly to ensure the pulley stays in place.
If the pulley continues to come off after these steps, professional inspection may be necessary.
This answer is automatically generated