Service And Adjustments - Husqvarna FT900 Operator's Manual

SERVICE AND ADJUSTMENTS
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into
contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 15)
Factory assembly has provided lowest handle height. Select
handle height best suited for your tilling conditions. Handle
height will be different when tiller digs into soil.
• If a higher handle height is desired, loosen the four
nuts securing handle panel to engine brackets.
• Slide handle panel to desired location.
• Tighten the four nuts securely.
ENGINE
BRACKETS
HANDLE
// PANEL
NUTS (ALSO 2
ON LEFT SIDE
OF TILLER)
Fig. 15
TINE ARRANGEMENT
Your outer tines can be assembled in several different ways
to suit your tilling or cultivating needs.
i CAUTION: Tines are sharp. Wear
gloves or other protection when han= |
dling tines.
NORMAL TILLING = 26 INCH PATH (See Fig. 16)
• Assemble holes '_' in tine hubs to holes "B" in tine
shaft.
CLEVIS OUTER
fPIN TINE
i o ofl
HAIRPIN CLIP INNER TINE
Fig. 16
13
MID-WIDTH TILLING - 24 INCH PATH (See Fig. 17)
• Assemble holes '_' in tine hubs to holes "C" in tine
shaft.
A C C A
[o_ 6o]
Fig. 17
NARROW TILLING/CULTIVATING - 12-3/4 INCH PATH
(See Fig. 18)
• Remove outer tines.
• w===_ IP==4 •
Oll IiO
INNER TINES ONLY
ool
tine 6
Fig. 18
NOTE: When reassembling outer tines, be sure right tine
assembly (marked "R") and left tine assembly (marked "1")
are mounted to correct side of tine shaft.